Table of Contents
Advertisement
XG700 User's Guide
4.1 Basic Switch Functions
This section describes the basic switch functions.
4.1.1 Switching Mode
The XG700 provides the following two switching modes.
Store-and-forward switching mode
After the XG700 has finished receiving a frame, it checks the FCS (Frame Check Sequence) and performs a validity
check (on packet size, etc.) before forwarding the frame. If the switch receives a frame with an error frame, it discards
it.
Cut-through switching mode
The XG700 transmits the frame to the destination as soon as the first 64 bytes of the frame are received with no errors.
Since the XG700 starts transmitting the frame before it has received the entire frame, this mode allows forwarding at
low latency.
To change the switching modes, carry out the following procedures in the administrator EXEC mode.
xg# configure terminal
xg(config)# bridge forward-mode
{cut-through | store-and-forward }
xg(config)# no bridge forward-mode
xg(config)# exit
4.1.2 MAC Address Table Management
MAC address table is a database used for managing the association between address information and destination ports.
The XG700 can learn up to 8912 entries of MAC addresses.
MAC address table management
The XG700 has two management methods for MAC address table management.
−
−
To change the MAC address table management modes, carry out the following procedures in the management EXEC
mode.
xg# configure terminal
xg(config)# bridge learn-mode { ivl | svl }
xg(config)# no bridge learn-mode
xg(config)# exit
xg# copy running-config startup-config
xg# reset
Dynamic MAC address learning
The XG700 dynamically learns MAC addresses from a received frame. If MAC addresses are not uploaded for a period
by the aging function, they will be removed frame MAC address table.
To disable the dynamic learning, carry out the following procedures in the administrator EXEC mode.
xg# configure terminal
xg(config)# interface port 1 2 3
xg(config)# interface port range 1 3
xg(config-if)# suppress-address-learning
xg(config-if)# no
suppress-address-learning
xg(config-if)# exit
xg(config)# exit
Command
SVL(Shared VLAN Learning)
The XG700 learns MAC addresses common to all VLANs. Different VLAN with identical MAC addresses are
treated as identical entries.
IVL(Independent VLAN Learning)
The XG700 learns MAC addresses separately for each VLAN. Identical MAC addresses with different VLANs
are treated as separate entries.
Command
Command
All Rights Reserved, Copyright (C) PFU LIMITED 2005-2006
Switch to global configuration mode.
Select the cut-through (or store-and-forward) for the
switching mode.
Exit to administrator EXEC mode.
Switch to the global configuration mode.
Select IVL or SVL for the MAC address table management
mode.
Exit to administrator EXEC mode.
Save the current settings of the XG700 to nonvolatile
memory.
If the MAC address table management mode is changed, the
new setting becomes enables after the XG700 is restarted.
Switch to global configuration mode.
Switch to the interface edit mode for the port for which you
want to change the configuration.
In this example, the global interface configuration mode is
selected for ports 1 through 3.
Disable (or enable) the dynamic MAC address learning.
Exit to global configuration mode.
Exit to administrator EXEC mode.
26/266
Task
Task
Task
Advertisement
Table of Contents
