Switch Port Side - Fujitsu XG2600 Hardware Manual

XG2600 Hardware Guide
1.1.4

Switch Port Side

PSU Slots for
Rear-Access Installation
PSU1
Power Supply Unit
Power Inlet
• PSU Slots for Rear-Access Installation
• Power Inlet
• Power Supply Unit
• SFP+ Slots
• Reset Switch
• USB Port
• Serial Port (Console Connection)
Caution
Serial Port is only used for connecting the switch with RS-232C interface of the console. Do not
connect other interfaces such as LAN/ISDN which cause an error.
Reference User's Guide "1.1.5 Console Port Specifications" (pg.29)
• Management Port
Port1
Port2
PSU2
Power Supply Unit
PSUs are plugged in the slots when the switch is used in Rear-Access configuration.
Plug the attached Power Cable in the package.
This switch is installed with two PSUs.
Plug SFP+ modules for connecting Ethernet based networking equipment (10GBASE-
SR/10GBASE-LR).
Port number is assigned from the upper side of the leftmost port to the right. For
example, Port 1 is the upper side of the leftmost port, and Port 26 is the lower side of the
right most port.
Press to reboot.
Insert a USB memory device to load/save configuration files or update firmware.
The Serial Port is used to connect the switch with the console (PC) for setting and
command line interface via the attached console cable adapter (RJ45 to Serial Adapter)
and RS232C crossover cable (D-SUB9).
This is used to connect Ethernet based (10/100BASE-TX) networking equipment. Use
Category-5 LAN cables.
The Management Port is MDI fixed. If you connect the device that have MDI fixed port
to the Management Port, please use the Crossover Cable.
22
Reset Switch
SFP+ Slots
Port25
Port26
Management Port
Items in the Package, Descriptions and Functions
Chapter 1 Getting Started
Serial Port
USB Port