Novell OPEN ENTERPRISE SERVER 2 SP 2 - CLUSTER SERVICES 1.8.7 FOR LINUX Manual page 43

IMPORTANT: If you want Novell Cluster Services to use a local eDirectory database on this
server, we recommend that you install and configure eDirectory before installing Novell Cluster
Services.
Repeat the following procedure for each server that you want to add to the cluster:
1 If you have a shared disk system and the server where you are installing Novell Cluster
Services is the second node in a cluster, verify that a cluster partition for the cluster's Split
Brain Detector exists on the first cluster node before you begin the install on the second node.
A one-node cluster that has shared disk storage can be configured without an SBD, but the
SBD must be created before you add another node.
IMPORTANT: The cluster SBD partition is not required unless you have shared storage.
For information, see:
Section 8.16.3, "Creating a Non-Mirrored Cluster SBD Partition," on page 111
Section 8.16.4, "Creating a Mirrored Cluster SBD Partition," on page 112
2 Start the YaST install for SUSE Linux Enterprise Server 10 and continue to the Installation
Mode page.
3 Select New Installation, select Include Add-On Products from Separate Media, click Next, then
continue through the OES 2 add-on part of the install until you get to the Installation Settings
page.
4 On the Installation Settings page, click Software to open the Software Selection and System
Tasks page.
5 Under OES Services, select Novell Cluster Services and any other OES components that you
want to install, then click Accept.
When you select Novell Cluster Services, the following basic services for managing OES 2 are
automatically selected:
Novell Backup / Storage Management
Installing and Configuring Novell Cluster Services on OES 2 Linux 43