Novell OPEN ENTERPRISE SERVER 2 SP 2 - CLUSTER SERVICES 1.8.7 FOR LINUX Manual page 205

Cluster Console Command
SCAN FOR NEW DEVICES
SET {Parameter} {Value}
Description
IMPORTANT: This command is obsolete on Linux.
For information about scanning for new devices on Linux,
see "Scanning for Devices
File System Administration
You can use the evms activate(8)
discover all EVMS volumes on Linux, and to activate kernel
devices for all volumes that are not yet active. For more
information, see the man page for
Sets cluster parameters individually for the cluster. See
Chapter 7, "Configuring Cluster Policies and Priorities," on
page 91 for more information on cluster parameters.
Specify one of the following parameters and a value for that
parameter:
sets the cluster IP address to the specified
IPADDRESS
value. If you change the cluster IP address, you must
restart cluster software on all cluster nodes.
PORT sets, or lets you change, the cluster port number.
QUORUMWAIT is the amount of time in seconds that the
cluster waits before resources start to load.
is the number of nodes that must be running in the
QUORUM
cluster before resources will start to load.
HEARTBEAT is the amount of time in seconds between
transmits for all nodes in the cluster except the master.
TOLERANCE is the amount of time in seconds that the
master node gives all other nodes in the cluster to signal
that they are alive.
MASTERWATCHDOG is the amount of time in seconds
between transmits for the master node in the cluster.
SLAVEWATCHDOG is the amount of time in seconds that the
slave nodes give the master node in the cluster to signal
that it is alive.
MAXRETRANSMITS is the maximum number of times
transmits will be attempted between the master node
and slave nodes.
ENABLEEMAIL enables and disables e-mail notification.
You can set the value to OFF to disable e-mail
notification, or either CRITICAL or VERBOSE to enable
e-mail notification.
EMAILADDRESSES lets you specify the e-mail addresses
used for e-mail notification. The addresses should be
separated by spaces. Using this parameter without
specifying any addresses clears existing addresses that
have been set previously.
sets the e-mail notification options.
EMAILOPTIONS
Specify XML as the value to receive e-mail notification in
XML format. Not specifying any value with this
parameter turns notification in XML format off.
Console Commands for Novell Cluster Services 205
(Linux)" in the OES 2 SP2: NSS
Guide.
command to
evms activate .