Novell OPEN ENTERPRISE SERVER 2 SP 2 - CLUSTER SERVICES 1.8.7 FOR LINUX Manual page 45

Repeat the following procedure for each server that you want to add to the cluster:
1 If you have a shared disk system and the server where you are installing Novell Cluster
Services is the second node in a cluster, verify that a cluster partition for the cluster's Split
Brain Detector exists on the first cluster node before you begin the install on the second node.
A one-node cluster that has shared disk storage can be configured without an SBD, but the
SBD must be created before you add another node.
IMPORTANT: The cluster SBD partition is not required unless you have shared storage.
For information, see:
Section 8.16.3, "Creating a Non-Mirrored Cluster SBD Partition," on page 111
Section 8.16.4, "Creating a Mirrored Cluster SBD Partition," on page 112
2 Log in to the server as the
3 In YaST, select Open Enterprise Server > OES Install and Configuration.
4 On the Software Selection page under OES Services, click Novell Cluster Services and any
other compatible OES components that you want to install.
Services that you have already installed are indicated by a blue check mark in the status check
box next to the service.
For information about the options, see
Services during a OES 2 Linux Installation," on page
5 Click Accept to begin the install, then click Continue to accept changed packages.
user.
root
Step 5 in Section 3.5.1, "Installing Novell Cluster
Installing and Configuring Novell Cluster Services on OES 2 Linux
42.
45