Configuring The Exchange Gateway; Enabling Directory Synchronization And Exchange Of Address Books; Exchange Gateway - Novell GROUPWISE 7 GATEWAY FOR MICROSOFT EXCHANGE - INSTALLATION AND ADMINISTRATION Installation And Administration Manual

Configuring the Exchange
8
Gateway
After the Exchange Gateway is up and running between the GroupWise
system, there are a variety of ways to refine its configuration to meet the specific needs of your e-
mail users.
Section 8.1, "Enabling Directory Synchronization and Exchange of Address Books," on
page 61
Section 8.2, "Configuring Addressing Instead of Using Directory Synchronization and
Exchange," on page 64
Section 8.3, "Changing the Link Protocol between the Exchange Gateway and the MTA," on
page 72
Section 8.4, "Controlling Gateway Access," on page 73
Section 8.5, "Setting Up Accounting," on page 81
Section 8.6, "Establishing Gateway Administrators," on page 84
Section 8.7, "Enabling Message Status for Sent Items," on page 85
Section 8.8, "Binding the Exchange Gateway to a Specific IP Address," on page 86
8.1 Enabling Directory Synchronization and
Exchange of Address Books
Directory synchronization and exchange enable the Exchange Gateway to automatically exchange
Address Book information between the GroupWise system and the Exchange system.
Directory Exchange: Causes the gateway to perform a nightly exchange of the Exchange
public Address Book and GroupWise Address Book.
Directory Synchronization: Causes the gateway to update each Address Book as changes in
Address Book information occur. If directory synchronization is not enabled, the Address
Books are not updated until the nightly directory exchange occurs.
IMPORTANT: To ensure proper replication of names and addresses in both systems, use both
directory synchronization and exchange.
1 Make sure that the Exchange system is set up to support directory synchronization and
exchange, as described in
Gateway," on page 31. You might want to double-check the trust level established for the
gateway.
2 If you have domains in your GroupWise system that contain users that you do not want to
appear in the Exchange version of the GroupWise Address Book, use the
the startup files (gwexch.cfg) to list the GroupWise domains that should not be included in
the directory synchronization and exchange process.
Chapter 5, "Configuring the Exchange Side of the Exchange
®
system and the Exchange
/blockdom switch in

Configuring the Exchange Gateway

8
61