Using Explicit Addressing; Setting Up An Addressing Rule To Facilitate Busy Searches - Novell GROUPWISE 7 GATEWAY FOR MICROSOFT EXCHANGE - INSTALLATION AND ADMINISTRATION Installation And Administration Manual

5 Select Novell GroupWise Address, then click OK.
6 In the Address field, specify the GroupWise user's address in the following format:
domain.post_office.user_ID
where domain is the name of the GroupWise domain, post_office is the name of the GroupWise
post office, and user_ID is the user's GroupWise ID.
7 Click OK, click Next, then click Finish.
The GroupWise user can now be selected from the Exchange Address Book.
Including Custom Users in Directory Synchronization
If you want to be able to change user information associated with custom recipients in Exchange and
have the information for the corresponding GroupWise user updated to match, you must enable
directory synchronization for custom recipients. In the Exchange Gateway startup file
(gwexch.cfg), use the
recipients. For more information about directory synchronization, see
Directory Synchronization and Exchange of Address Books," on page

8.2.4 Using Explicit Addressing

If you do not enable directory synchronization and exchange, and if users are not represented in the
other e-mail system's Address Book, then users on both sides of the gateway must use explicit
addressing. See "Addressing Messages" on page
8.2.5 Setting Up an Addressing Rule to Facilitate Busy
Searches
When performing a busy search, the Exchange server uses LDAP to identify the users being
searched, rather than the typical recipient information used when delivering messages. If users' e-
mail addresses do not match their mailbox names, messages are delivered successfully but busy
searches fail.
You can use the /addressrule
the gateway to use when it sends a busy search request to the Exchange system. With the /
addressrule startup switch, you can use the following tags to specify the address format you want:
<domain>
<username>
/custom startup switch to enable directory synchronization for custom
57.
startup switch in the
gwexch.cfg
Section 8.1, "Enabling
61.
file to define the format you want
Configuring the Exchange Gateway 71