Configuring The Groupwise Side Of The Exchange Gateway; Providing Foreign System Configuration Information - Novell GROUPWISE 7 GATEWAY FOR MICROSOFT EXCHANGE - INSTALLATION AND ADMINISTRATION Installation And Administration Manual

Configuring the GroupWise Side
6
of the Exchange Gateway
After you have configured the Exchange side of the gateway, you must configure the GroupWise
side of the gateway by configuring the Exchange Gateway object in ConsoleOne
Section 6.1, "Providing Foreign System Configuration Information," on page 51
Section 6.2, "Providing Gateway Information," on page 53
6.1 Providing Foreign System Configuration
Information
1 In ConsoleOne, connect to the domain where you installed the Exchange Gateway
item 4), then select the Domain object.
2 Right-click the Exchange Gateway object, then click Properties.
3 On the Foreign System Configuration page, click Default to populate the fields.
NOTE: If the Foreign System Configuration page is not available, then the Exchange Gateway
snap-in is not installed in ConsoleOne.

Configuring the GroupWise Side of the Exchange Gateway

®
®
.
(worksheet
6
51