Configuring Addressing Instead Of Using Directory Synchronization And Exchange; Adding Individual Exchange Users To The Groupwise Address Book - Novell GROUPWISE 7 GATEWAY FOR MICROSOFT EXCHANGE - INSTALLATION AND ADMINISTRATION Installation And Administration Manual

users and Exchange users can select each other out of their familiar Address Books. Addressing is
not an issue under these circumstances.
If you do not want to enable directory synchronization and exchange, you must use other addressing
alternatives:
8.2.1 Adding Individual Exchange Users to the GroupWise
Address Book
If there are some specific Exchange users who you want to appear in the GroupWise Address Book,
you can add those individual users without enabling directory synchronization and exchange. You
add Exchange users to the GroupWise Address Book by defining them as external users and then
specifying the explicit addresses required to route messages to them in the Exchange system.
1 In ConsoleOne, select GroupWise System, select the non-GroupWise domain that represents the
2 Right-click the GroupWise Post Office object that represents the Exchange site or
3 Type a username, then click OK.
64 GroupWise 7 Gateway for Microsoft Exchange Installation and Administration Guide
Section 8.2.1, "Adding Individual Exchange Users to the GroupWise Address Book," on
page 64
Section 8.2.2, "Adding Individual Exchange Users to Personal Address Books," on page 66
Section 8.2.3, "Adding Individual GroupWise Users to the Exchange Address Book," on
page 67
Section 8.2.4, "Using Explicit Addressing," on page 71
Section 8.2.5, "Setting Up an Addressing Rule to Facilitate Busy Searches," on page 71
Exchange system, then select the external post office that represents the Exchange site or
administrative group where the Exchange user is located.
administrative group, then click New > External User.