Httprefresh; Httpuser; Importsubcontainers - Novell GROUPWISE 7 GATEWAY FOR MICROSOFT EXCHANGE - INSTALLATION AND ADMINISTRATION Installation And Administration Manual

Example:
See also /httpuser, /httppassword, and /httprefresh.

11.13 /httprefresh

Specifies the rate at which the Exchange Gateway refreshes the status information in your Web
browser. The default is 60 seconds. See
on page
Syntax:
Example:
See also /httpuser, /httppassword, and /httpport.

11.14 /httpuser

Specifies the username for the Exchange Gateway to prompt for before allowing gateway status
information to be displayed in a Web browser. Providing a username is optional. Do not use an
existing eDirectory username because the information passes over the non-secure connection
between your Web browser and the Exchange Gateway. See
Gateway Web Console," on page
Syntax:
Example:
See also /httppassword, /httpport, and /httprefresh.

11.15 /importsubcontainers

Causes the gateway to include all nested subcontainers when importing Exchange users from
Exchange export containers as part of the connector configuration process See
"Configuring the Exchange Side of the Exchange Gateway," on page
Syntax:
11.16 /ip
Binds the Exchange Gateway to a specific IP address when the server where it runs uses multiple IP
addresses, such as in a clustering environment. The specified IP address is associated with all ports
used by the gateway (message transfer and HTTP). Without the /ip switch, the gateway binds to all
112 GroupWise 7 Gateway for Microsoft Exchange Installation and Administration Guide
httpport-7175
92.
/httprefresh-seconds
/httprefresh-30
/httpuser-username
/httpuser-GateWatcher
/importsubcontainers
Section 9.2, "Using the Exchange Gateway Web Console,"
92.
Section 9.2, "Using the Exchange
Chapter 5,
31.