Determining Connections Between Systems; Selecting User Address Type And Format; Section 3.7, "Determining Connections Between Systems; Section 3.8, "Selecting User Address Type And Format - Novell GROUPWISE 7 GATEWAY FOR MICROSOFT EXCHANGE - INSTALLATION AND ADMINISTRATION Installation And Administration Manual

3.7 Determining Connections between Systems

To facilitate addressing of messages between systems, you must set up a representation of the
Exchange system in your GroupWise system and a connector to your GroupWise system in your
Exchange system.
In GroupWise, non-GroupWise systems are represented by non-GroupWise domains. When you
first start the Exchange Gateway, the non-GroupWise domain for the Exchange system is created
automatically. By default, it is named after the Exchange organization. Under the non-GroupWise
domain for the Exchange system, an external post office is automatically created for the Exchange
site or administrative group on the Exchange server. By default, it is given the same name as the
Exchange site or administrative group. If necessary, you can specify different names for the non-
GroupWise domain and external post office.
EXCHANGE GATEWAY INSTALLATION WORKSHEET
Under Item 12: Non-GroupWise
Exchange organization) or specify a name for the non-GroupWise domain.
Under Item 13: External Post
site or administrative group) or specify a name for the external post office.
In Exchange, non-Exchange systems link to the Exchange system through connectors. On the
Exchange side, you might want to call the Exchange Gateway GroupwiseConnector, because it
connects the Exchange system to GroupWise.
EXCHANGE GATEWAY INSTALLATION WORKSHEET
Under Item 6: Gateway Details, specify the name you want to use in Exchange to represent the link to
the GroupWise system.

3.8 Selecting User Address Type and Format

By default, every Exchange user will have a GroupWise-type address with the following format:
GWise:domain.post_office.user_ID
GWise is the default Exchange address type created for the GroupWise system. You can change it if
needed.
EXCHANGE GATEWAY INSTALLATION WORKSHEET
Under Item 11: GroupWise Address Type in Exchange
default address type (GWise) or specify the address type name you want to use.
Exchange user addresses are generated automatically when you start the Exchange Gateway, using
the format shown above. As described earlier, the Installation program maps the name of the
Exchange organization to the GroupWise domain portion of the address, the name of the Exchange
site or administrative group on the server to the post office portion of the address, and the Exchange
user mailbox name to the GroupWise user ID portion of the address.
Domain, mark whether you want to use the default name (the
Office, mark whether you want to use the default name (the Exchange
System, mark whether you want to use the
Planning the Exchange Gateway Installation 19