Novell GROUPWISE 7 GATEWAY FOR MICROSOFT EXCHANGE - INSTALLATION AND ADMINISTRATION Installation And Administration Manual page 104

2 Click GroupWise > Gateway Time Settings to display the Gateway Time Settings page.
3 Fill in the following fields:
4 Click OK to save the updated time settings.
Exchange Gateway Web Console You can adjust these settings for the current gateway session on
the Time Settings
104 GroupWise 7 Gateway for Microsoft Exchange Installation and Administration Guide
Send/Receive Cycle: Specify the maximum amount of time you want the gateway to spend
sending and receiving messages during one cycle. The default cycle is 120 seconds, which
causes the gateway to send messages for a maximum of 60 seconds and to receive messages for
60 seconds. The cycle is then repeated.
If the time limit is reached and a message is being processed, the gateway finishes processing
the message.
Minimum Run: This field does not apply to the Exchange Gateway.
Idle Sleep Duration: Specify the number of seconds the gateway is to remain idle if it has no
commands or messages to process. The default value is 30 seconds.
The gateway constantly polls its directory for messages to process. The purpose of idle time is
to save CPU cycles and to keep network traffic manageable.
Snap Shot Interval: The Exchange Gateway server console shows the gateway statistics for
the last x minutes (an interval you specify). The default interval is 10 seconds. Gateway activity
is updated every minute.
ConsoleOne then notifies the Exchange Gateway to restart so the new settings can be put into
effect.
page.