Deployment Procedure; Deploying A Cluster Of Single-Machine Ssl Vpns - Novell ACCESS MANAGER 3.1 SP1 - SSL VPN SERVER GUIDE 03-17-2010 Manual

8.1.2 Deployment Procedure

To install the ESP-enabled Novell SSL VPN on a single machine:
1 Install the Administration Console.
For more information on installing the Administration console, see
Manager Administration
2 Install the Identity Server and the SSL VPN server by using the
For more information on installing the Identity Server, see
SSL VPN and the Identity Server on the Same Machine" on page
3 Configure the Identity Server.
For more information on configuring the Identity Server, see
Server"in the Novell Access Manager 3.1 SP1 Identity Server
4 Assign the Security certificate.
For more information, see
SP1 Setup Guide.
5 The SSL VPN server is auto-imported into the Administration Console after the installation.
Establish a trust relationship between the Identity Server and the SSL VPN server.
For more information, see
SSL VPN," on page
6 In the Administration Console, select Devices > SSL VPNs. The health status at this stage
should be green, indicating that the SSL VPN server is properly imported into the
Administration Console and a trust relationship between the Identity Sever and the SSL VPN
server has been established.
7 Configure the Client Integrity check policies and other relevant configurations for SSL VPN.
For more information on configuring the SSL VPN, see
page 65.
8.2 Deploying a Cluster of Single-Machine SSL
VPNs
In a single-machine cluster of SSL VPNs, SSL VPN, the Identity Server, and the Administration
Console are all installed on a single machine and several of these SSL VPNs are clustered. In this
deployment scenario, the ESP-enabled Novell SSL VPN is used. You can deploy SSL VPN along
with the Identity Server cluster or on a single Identity Server.
The following sections document the prerequisites and the procedure that are involved in
configuring a cluster of single machine SSL VPNs:
Section 8.2.1, "Deployment Scenario," on page 60
Section 8.2.2, "Prerequisites," on page 60
Section 8.2.3, "Deployment Procedure," on page 60
Console" in the Novell Access Manager 3.1 SP1 Installation
"Enabling SSL Communication" in the
Chapter 9, "Configuring Authentication for ESP-Enabled Novell
67.
"Installing the Access
script.
install.sh
"Deployment Scenario 2: Installing
31.
"Configuring an Identity
Guide.
Novell Access Manager 3.1
Part III, "Configuring SSL VPN," on
Guide.
Deploying SSL VPN 59