Novell ACCESS MANAGER 3.1 SP1 - SSL VPN SERVER GUIDE 03-17-2010 Manual page 78

3 Specify the device-specific configuration as follows:
Cluster Member: Select the cluster member from a list of IP addresses.
Listening IP Address: Specify the IP address that the SSL VPN listens on.
Port: Specify a port number for Kiosk mode as well as for Enterprise mode when the SSL
VPN server is behind an L4 or a NAT. Make sure that the port you specify here is free.
Protocol: Specify a protocol for Kiosk mode as well as for Enterprise mode, when the SSL
VPN server is behind an L4 or a NAT. The protocol is TCP for Kiosk mode, but it can either be
TCP or UDP for Enterprise mode.
4 Specify the following information to configure the assigned IP address pool for Enterprise
mode:
Subnet Address: Specify the IP address of the subnet pool where SSL VPN assigns the IP
address to each client in Enterprise mode. For this assigned IP address pool to work properly,
you must configure the routing table and source NAT. For more information, see
"Configuring Route and Source NAT for Enterprise Mode," on page
Subnet Mask: Specify the subnet mask for Enterprise mode.
78 Novell Access Manager 3.1 SP1 SSL VPN Server Guide
Chapter 12,
81.