Post-Deployment Tasks - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - ZENWORKS APPLIANCE DEPLOYMENT AND ADMINISTRATION REFERENCE 10.3 16-04-2010 Deployment Manual

Configuring the ZENworks Reporting Server
1 In the ZENworks Reporting Server Wizard, read the introductory text, then click Next.
2 (Conditional) If the ZENworks Reporting Server has already been configured in your zone, you
are prompted to decommission the existing ZENworks Reporting Server.
To use the existing ZENworks Reporting Server, click Cancel to cancel the ZENworks
Reporting Server configuration.
To configure the ZENworks Reporting Server on ZENworks Appliance, click OK.
The existing ZENworks Reporting Server is decommissioned and the ZENworks Reporting
Server configuration begins on ZENworks Appliance. The ZENworks Reporting Server
configuration requires no user interaction.
For more information on how to decommission the existing ZENworks Reporting Server, see
"Decommissioning an Existing Instance of ZENworks Reporting
Configuration Management Reporting Server Installation
3 After the configuration is complete, click Done.

3.3 Post-Deployment Tasks

The minimum disk space required for a virtual machine to deploy ZENworks Appliance is 50 GB.
Depending on your requirement, you can increase the disk space after deploying ZENworks
Appliance by performing the tasks in the following sections:
Section 3.3.1, "Creating a New Hard Disk," on page 26
Section 3.3.2, "Partitioning and Configuring a New Hard Disk," on page 26
Server" in the ZENworks 10
Guide.
Deploying ZENworks Appliance 25