Table of Contents
Advertisement
31.3 SSL VPN Connects in Kiosk Mode, But
There Is No Data Transfer
If the user is able to successfully connect in Kiosk mode, but the data transfer does not happen,
check to see if the user is configured to connect through a forward proxy, then verify that the entries
in the
proxy.conf
to Connect through a Forward Proxy," on page
31.4 The TFTP Application and GroupWise
Notify Do Not Work in Enterprise Mode
If the TFTP application and GroupWise
have done the following:
You have configured a route using the default gateway. For more information, see
"Configuring Route and Source NAT for Enterprise Mode," on page
You are not using source NAT to route packets.
31.5 SSL VPN Not Reporting
If SSL VPN is not reporting, you must verify the status of JCC and the SSL VPN server and restart
them if they are down. If restarting any of these components does not work, reconfigure SSL VPN.
If none of these work, you must delete and reimport the SSL VPN server.
Section 31.5.1, "Verifying and Restarting JCC," on page 162
Section 31.5.2, "Verifying and Restarting the SSL VPN Server," on page 162
31.5.1 Verifying and Restarting JCC
To check the status of JCC, enter the following command:
/etc/init.d/novell-jcc status.
If it is not running, enter the following command to restart JCC:
/etc/init.d/novell-jcc restart
31.5.2 Verifying and Restarting the SSL VPN Server
To verify the status of the SSL VPN server, enter the following command:
/etc/init.d/novell-sslvpn status
If any component is down, stop and start the SSL VPN server by using the following commands:
novell-sslvpn stop
novell-sslvpn start
162 Novell Access Manager 3.1 SP1 SSL VPN Server Guide
file are correct. For more information, see
®
Notify do not work in Enterprise mode, make sure you
Chapter 17, "Configuring SSL VPN
109.
Chapter 12,
81.
Advertisement
Chapters
Table of Contents
Troubleshooting
Need help?
Do you have a question about the ACCESS MANAGER 3.1 SP1 - SSL VPN SERVER GUIDE 03-17-2010 and is the answer not in the manual?