Novell ACCESS MANAGER 3.1 SP1 - SSL VPN SERVER GUIDE 03-17-2010 Manual page 63

2 Install the Identity Server.
For more information on installing the Identity Server, see
Server" in the Novell Access Manager 3.1 SP1 Installation
3 Configure the Identity Server.
For more information on configuring the Identity Server, see
Server"in the Novell Access Manager 3.1 SP1 Identity Server
4 Assign the security certificate.
For more information, see
SP1 Setup Guide.
5 Install the Linux Access Gateway server.
For more information, see
Access Manager 3.1 SP1 Installation
During the installation steps, make sure that you select Enable SSL VPN Service, to install SSL
VPN along with the Linux Access Gateway.
The SSL VPN server is auto-imported into the Administration Console after the installation.
6 Configure the Linux Access Gateway to accelerate and protect the SSL VPN Server.
For more information, see
page 69.
7 In the Administration Console, select Devices > SSL VPNs. The health status at this stage
should be green indicating that the SSL VPN server is properly imported into the
Administration Console and a trust relationship between the Identity Sever and the SSL VPN
server has been established.
8 Configure the Client Integrity check policies and other relevant configurations for SSL VPN.
For more information on configuring the SSL VPN, see
page 65.
"Enabling SSL Communication" in the
"Installing the Linux Access Gateway
Guide.
Chapter 10, "Accelerating the Traditional Novell SSL VPN," on
"Installing the Novell Identity
Guide.
"Configuring an Identity
Guide.
Novell Access Manager 3.1
Appliance" in the
Part III, "Configuring SSL VPN," on
Novell
Deploying SSL VPN 63