CARLO GAVAZZI WM5-96 - PROGRAMMING Instruction Manual page 25

WM5-96 Instruction Manual
* * * * * * D D I I G G I I T T A A L L O O U U T T P P U U T T S S * * * * * *
ING. C1
PULSE
ING. C2
5a
ALARM
ING. C3
A A L L A A R R M M REMOTE CONTR.
N N D D
5
* * * * * * D D I I G G I I T T A A L L O O U U T T P P U U T T S S * * * * * *
OUT D0
OUT D1
OUT D2
A A L L A A R R M M
N N D D
6
The digital outputs highlighted in the
below mentioned table, are subject to
a self test that implies their brief acti-
vation when the instrument is switched on.
Their use as pulse outputs is therefore not
recommended.
Programming WM5 96
ALARM (5): the digital output is enabled only if the expected alarm
status occurs. Select the ALARM function by means of the "
keys and confirm with the "S" keys (5a).Then select "ND" (normally
de-energized relay) or "NE" (normally energized relay)
of the "
the "alarm" menu.
REMOTE CONTR. (5): the digital output can be enabled by means of a
command sent by means of serial port. Select the REMOTE CONTR. func-
tion by means of the "
ND
5b
Proceed, if necessary, with the configuration of the other digital out-
NE
puts (6).
Code
AO1058
AO1059 1 open coll. output A0
AO1035
AO1036 2 open coll. outputs A0 A1
AO1037 4 open coll. outputs A1 A2 A3 A4 B1 B2 B3 B4 C1 C2 C3 C4 D1 D2 D3 D4
(19-1)
" keys. To program the values of the set-points refer to
" keys, then press the "S" key to confirm.
Description Slot A
1 relay output A0
2 relay outputs A0 A1
23
(5b) by means
Slot B Slot C
B0 C0 D0
B0 C0 D0
B0 B1 C0 C1 D0 D1
B0 B1 C0 C1 D0 D1
"
Slot D