Optical Port - CARLO GAVAZZI WM5-96 - PROGRAMMING Instruction Manual

WM5-96
Smart Power Quality Analyzer
Programming WM5 96
Class 0.2 A/V
32
ARM Powered
R

Optical port

measures
PRG
a
S S
b
c
f
* * * * * * * * S S E E R R I I A A L L M M E E N N U U * * * * * * * *
RS232
ANSI
RS485
MODBUS
OTTICA
A A N N S S I I
PULSE
4
* * * * O O P P T T I I C C A A L L O O U U T T M M E E N N U U * * * *
ENERGY TYPE
PULSES
5
1.0000
PULSE/kWh
0.0010
min
10000
max
123...
5c
AL
R
The serial optical port
device (e-b). The connection
netic connector
port (depending on the model being used): the user will then be able
to read, transmit or receive information on the WM5 programming (the
!
d WM5Soft software can be purchased on request).
The optical port makes it also possible to retransmit the energy meter-
ing by means of pulses . In this case the light generated by the opti-
e
cal port is not visible because it's within the infrared spectrum. Set the
desired type of use of the optical port (energy transmission by means
of pulses or MODBUS or ANSI serial communication) before using it.
Follow steps
(2) by means of the "
select the type of protocol/communication mode
ANSI (4): standard ANSI serial communication protocol. Choose the
ANSI function by means of the "
MODBUS (4): MODBUS serial communication protocol. Choose the
MODBUS function by means of the "
"S". Then set the relevant parameters such as baud rate and parity,
see steps
PULSE (4): the port will be enabled for the energy retransmission.
Select the PULSE function by means of the "
with "S". Then select the energy type to be retransmitted (5), select
ENERGY TYPE by means of the "
The instrument will display the list of available energies
kWh-, kvarh+, kvarh-) (5a); select the desired energy by means of the
"
ble to choose if retransmitting the total energy metering (TOT) or by
tariff from T1 to T12 (5b), choose the desired energy detail by means
of the "
pulse related to the measured energy, that is the number of pulses
generated for each measured kWh+ (or kWh- or kvarh+ or kvarh-).
Choose PULSE
"S", then
the "S" key.
Note: set the optical port in the MODBUS mode before using it relat-
ed to the serial communication software "Wm5Soft".
kWh +
kWh -
kvarh +
5a
kvarh -
TOT
L1
L2
5b
L3
(d) transmits the data by means of an infrared
(c)
(a) is made by means of a USB port
(1) and (2) on the previous page, then select "OPTICAL"
" keys and confirm with "S". Afterwards,
(3b) and (3c) on the previous page.
" keys and confirm with the "S" key: for each energy it's possi-
" keys and confirm with "S". Finally, set the value of the
(5) by means of the "
(5c) set the desired pulse value and confirm it by means of
WM5-96 Instruction Manual
to the PC through the relevant mag-
(f)
(4) to be used:
" keys and confirm with "S".
" keys and confirm with
" keys and confirm
" keys and confirm with "S".
" keys and confirm with
or 232 serial
(5a) (kWh+,