Concerning Control Buttons For Configuration And Adjustment - Sanyo VDC-DP9584N - Network Camera Instruction Manual

Concerning Control Buttons for Configuration and Adjustment

Using the Camera Control Unit (VAC-70: Separately ordered)
Camera can be controlled remotely during setting or adjustment.
• Please refer to the instruction manual for VAC-70.
Button operations with VAC-70 are the same as with the unit.
• When configuration and adjustment are finished, always disconnect
the Camera Control Unit.
(VAC-70)
1
(Main unit)
GND
MONITOR
OUT
SET
UP
LEFT
2
RIGHT
DOWN
3
Using the Control Buttons on the Circuit Board
Regarding connection of the monitor, see the separate installation
manual.
• When configuration and adjustment are finished, always disconnect
the monitor and install the dome cover.
■ To display the main menu
VAC-70: Press the MENU button 1.
Main unit: Hold down the SET button 3 for over a second.
■ To operate the menu screen
• Select the item and change the setting value by pressing the Select
button 2.
• Enter the advanced settings screen by pressing the SET button 3.
■ To conduct pan/tilt and zoom
• The pan/tilt and zoom functions can be operated using the Select
button 2 during live mode (with no settings screen displayed).
• Press the SET button 3 to switch over between pan/tilt and zoom
operations.
<Pan/Tilt operations>
Pan: Press d(LEFT) or c(RIGHT)
Tilt: Press j(UP) or l(DOWN)
<Zoom operations>
Wide: Press d(LEFT)
Tele: Press c(RIGHT)
6