Returning To Specified Monitoring Mode Automatically <Auto Return - Sanyo VDC-DP9584N - Network Camera Instruction Manual

Returning to Specified Monitoring Mode Automatically <AUTO RETURN>
Performing a manual operation on the angle of view (pan, tilt, or zoom) cancels the current monitoring mode (sequential pan,
auto pan, preset position). However, you can set the camera to return to the specified monitoring mode automatically once the
manual operation is over.
1
Set <AUTO RETURN> to "ON" and press the SET
button.
CAMERA
PRESET POSITION
AUTO MODE
·AUTO RETURN
ALARM
PASSWORD
·AUTO RETURN ON LANGUAGE
OPTION
RThe "AUTO RETURN" screen appears.
2
Select <MODE> to specify the monitoring mode
for auto return.
·MODE
Returns to sequential panning.
SEQ :
PAN : Returns to automatic intermittent panning.
Returns to the registered preset position (PRESET
PRE 1 – 16 :
NO. 1 - 16).
SET y
1 y
R
SEQ y
ON y
SET y
SET y
SET y
SET y
AUTO RETURN
·MODE SEQ
TIME 1M
3
Select <TIME> to set the timing to return to the
specified monitoring mode.
SET
·TIME
• Select from: 10S, 20S, 30S, 40S, 50S, 1M, 2M, 3M, 4M, 5M,
Note: <TIME> specifies the pause after manual operation.
4
Select <MENU> – "BACK" and press the SET
button.
RReturns to the main menu.
■ If you want to close the settings screen
Set <MENU> to "END" and press the SET button.
■ To cancel an auto return in the main menu
Change <AUTO RETURN> – "ON" to "OFF".
AUTO RETURN
MODE
·TIME
6M, 7M, 8M, 9M, 10M (S=second, M=minute)
For accessing the main menu, see pages 7 – 8.
SEQ
1M
34