Tutorial 2 - Create A Birdhouse Drawing - Autodesk 003A1-121111-1001 - AutoSketch v.9.0 Getting Started

Tutorial 2 — Create a
Birdhouse Drawing
In this tutorial, you learn how to use AutoSketch
create a birdhouse drawing. You create a single entity
from scratch, and you create an entity by grouping and
rubber-stamping an existing entity. You also add
dimensions and a title, and then place them on the
appropriate layers. Finally, you print the drawing.
More information about each of the concepts in this
tutorial is available in the Help system.
®
to
In this tutorial
■
Introduction
■
Set Up the Birdhouse Drawing
■
Create the Floor of the
Birdhouse
■
Add Dimensions to the Floor of
the Birdhouse
■
Add a Title to the Floor of the
Birdhouse
■
Create the Back of the
Birdhouse by Grouping and
Rubber-Stamping
■
Add Dimensions to the Back
■
Add a Title to the Back
■
Print the Completed Birdhouse
Drawing
51