System Setup For Multi-Zone - Denon AVR-5805CI Operating Instructions Manual

System setup for multi-zone

• This makes possible to make the optimum setting for the
speaker systems used in ZONE2.
1
Select the ZONE2 mode using the
button.
2
SYSTEM SETUP
Press the
• The ZONE2 system setup menu appears.
The screen displayed depends on the settings made at
"Channel Setup" (
Example: When "ZONE2" is set for a 5.1 or 7.1 channel
system
Example: When "ZONE2" is set for a STEREO or MONO
• For instructions on making the settings (
Adjustment steps that need to be performed
prior to surround sound playback in ZONE2
2 Test Tone
• Before playing with the surround function, be sure to use
the test tones to adjust the playback level from the
different speakers. This adjustment can be performed with
the system setup (
control unit, as described below.
• Adjusting with the remote control unit using the test tones
is only possible in the "Auto" mode and only effective in
the STANDARD (DOLBY/DTS SURROUND) modes. The
adjusted levels for the different modes are automatically
stored in the memory.
1
Select the ZONE2 mode using the
button.
2
TEST TONE
Press the
• The "Test Tone" screen appears.
button.
page 126 ~ 128).
page 120 ~ 125).
page 122, 123) or from the remote
button.
AMP
3
Press the
the speakers to the same volume.
4
After completing the adjustment, press the
TEST TONE
2 Channel Level
• After adjusting using the test tones, adjust the channel
levels either according to the playback sources or to suit
your tastes, as described below.
1
Select the ZONE2 mode using the
button.
2
Press the
• The "Channel Vol." screen appears.
3
Press the
button to select the speaker.
The channel switches as shown below each time the
CH SEL/ENTER button is pressed.
ZONE2 surround back speakers are only displayed when
"7.1ch" is selected for the ZONE2 channel output
setting at "Channel Setup" (
When the ZONE2 surround back speaker setting is set
to "1spkr" for "Speaker Configuration", this is set to
"SB".
4
Press the
level.
AMP
The adjustment range for the different channels is
+12.0 dB to –12.0 dB.
The sound from the subwoofer can be completely cut
by lowering the SW (subwoofer) setting one additional
step from –12.0 dB (setting it to "OFF").
95
Advanced Operation
CURSOR F F or G G button to adjust all
button again.
CH SEL/ENTER
button.
CURSOR CH SEL/ENTER
D D , H H or
FL C FR SW
FADER SL SBL SBR
page 126 ~ 128).
CURSOR
F F or G G button to adjust the
AMP
SR