Setting The Low Frequency Distribution - Denon AVR-5805CI Operating Instructions Manual

• Select "Large" or "Small" not according to the actual size of
the speaker but according to the speaker's capacity for
playing low frequency (bass sound below the frequency set
for the Crossover Frequency) signals. If you do not know, try
comparing the sound at both settings (setting the volume to
a level low enough so as not to damage the speakers) to
determine the proper setting.
Parameters
2
Large:
Select this when using speakers that can fully reproduce
deep bass well below 80 Hz.
Small:
Select this when using speakers that are not capable of
handling deep bass well below 80 Hz. Most home theater
main and surround speakers perform best when configured
as SMALL. Deep bass content in any channel with a
SMALL speaker is routed to the subwoofer(s).
None:
Select this when no speakers are installed.
Yes / No:
Select "Yes" when a subwoofer is installed, "No" when a
subwoofer is not installed.
2spkrs / 1spkr:
Select the number of speakers to be used for the surround
back channel.
A subwoofer with sufficient low frequency playback
capability can better handle deep bass than most main and
surround speakers, and the system's overall performance
will be greatly enhanced when SMALL is set for the main
(front) and surround speakers.
To take full advantage of the performance of the Home THX
certified speaker systems, set the front, center and
surround speaker size parameters to "Small" and the
subwoofer to "Yes".
For the majority of speaker system configurations, using
the SMALL setting for all main and surround speakers and
connected subwoofer(s) set to ON will yield the best
results.
When "Front" is set to "Small", "Subwoofer" is
automatically set to "Yes", and when "Subwoofer" is set
to "No", "Front" is automatically set to "Large".

Setting the low frequency distribution

• This selects the subwoofer for playing deep bass signals.
1
CURSOR
Press the
"Subwoofer Setup" at the "Speaker Setup"
menu, then press the
• The "Subwoofer Setup" screen appears.
2
CURSOR
Press the
setting.
LFE–THX–:
For any channel(s) that are set to LARGE, low
frequencies in that channel's corresponding source
are directed to that loudspeaker only. Low
frequencies that are directed to the subwoofer(s)
are from the program source LFE channel, and
from other channels where the speakers are set to
SMALL. THX recommends this mode so that bass
interference is less likely to occur in the room.
LFE+Main:
Low frequencies from speaker channels that have
been set to LARGE are reproduced from those
speakers as well as from the subwoofer(s).
Depending upon the characteristics of the LARGE
main speakers, this mode may provide a more even
low frequency response throughout the listening
room.
3
ENTER
Press the
• The "Speaker Setup" menu reappears.
141
Advanced Setup – Part 2
D D or H H button to select
ENTER
button.
F F or G G button to select the
button to enter the setting.