Input Mode; Room Eq Function - Denon AVR-5805CI Operating Instructions Manual

Basic Operation
2 Input mode indicator
• In the AUTO mode
• In the DIGITAL PCM mode
• In the DIGITAL DTS mode
• In the ANALOG mode
• In the EXT. IN mode
2 Input signal indicator
• DOLBY DIGITAL
Depending on the input signal.
• PCM
• The "DSD" indicator lights when the DENON
LINK or IEEE1394 have been connected and
the DSD signals have been input (
35, 38).
Depending on the input signal.
• The "HDCD" indicator lights when digital
signals are being input with a player that
supports HDCD playback.
The "DIG." indicator lights when digital signals are being
input properly. If the "DIG." indicator does not light, check
whether the "Digital In Assign" (
connections are correct and whether the component's
power is turned on.
AL24 processing is activated when PCM signals are played
while the surround mode is set to PURE DIRECT, DIRECT,
STEREO, MULTI CH PURE DIRECT, MULTI CH DIRECT or
MULTI CH IN.
Advanced AL24 processing is activated when PCM (2
channel) signals are played while the surround mode is set
to PURE DIRECT or DIRECT.
NOTE:
• The "DIG." indicator will light when playing CD-ROMs
containing data other than audio signals, but no sound will
be heard.
ROOM EQ
Depending on the input signal.
• DTS
page 104) and
ROOM EQ

Room EQ function

• The AVR-5805CI's Auto Setup / Room EQ function offers
three correction curves: "Audyssey", "Front", "Flat". The
timbre of the speakers can also be adjusted manually using
a graphic equalizer.
Details of the different correction curves are described
below.
ROOM EQ
Press the
• The Room EQ switches as follows each time the ROOM
EQ button is pressed.
OFF Audyssey
The "Audyssey" is selected, the MultEQ XT indicator
lights green.
The "Front" or "Flat" is selected, the MultEQ XT
indicator lights red.
The MultEQ XT indicator also lights red if the "Speaker
Configuration", "Delay Time", "Channel Level" or
"Crossover Frequency" is set manually after conducting
the Auto Setup procedure.
Audyssey:
This adjusts the frequency response of all speakers to
correct the effects of room acoustics.
Front:
This adjusts the characteristics of each speaker to the
page
characteristics of the front speakers.
Flat:
This the frequency response of all speakers flat.
This is suitable for multi-channel music reproduction,
from discrete music sources such as Dolby Digital 5.1,
DTS, DVD-Audio and Super Audio CD.
Manual:
Selects the setting value that was set in the Manual EQ
Setup.
For details of the "Manual EQ Setup" (
• The "Audyssey", "Front" and "Flat" Room EQ curves can
be selected after performing the Auto Setup procedure.
48
button.
Front Flat Manual
page 118, 119).