Setting The Learning Function; Using The System Call Function - Denon AVR-5805CI Operating Instructions Manual

Advanced Operation
AMP
SYSTEM CALL
CHANNEL

Setting the learning function

• If your AV device is a brand other than DENON or if operation
is not possible using the preset memory function, the signals
of a remote control unit of that device can be stored in the
AVR-5805CI's remote control unit.
• For some remote control units, it may not be possible to
learn the signals or the device may not operate properly after
the signals are learnt. In this case, use the remote control
unit of that device.
1
Press and hold the
least 3 seconds.
• The IR segment blinks twice.
2
9 7 5
, , button (9 → → 7 → → 5) in that
Press the
order.
• The IR segment blinks twice and the learning mode
is set.
3
MODE SELECTOR
Press the
device to be operated.
Learning is not possible for the AMP, ZONE2, ZONE3,
ZONE4 and SYSTEM CALL modes.
4
Press the button to be set.
• The display will go off and the unit will enter the
learning standby mode.
If a button that cannot be learnt is pressed, the IR
segment lights and the setting is canceled.
Cannot be set at the HOME button.
IR segment
MODE SELECTOR
NUMBER
RC SETUP
RC SETUP
button for at
button for the
5
Point the remote control units straight at each
other and press and hold in the button on the
other remote control unit to be learnt on the
AVR-5805CI's remote control unit.
• The display turns on again and the IR segment blinks
twice to indicate that the code is successfully
captured.
Other buttons can be learnt by repeating steps 4 and 5.
The mode can be switched by pressing a MODE
SELECTOR button.
If the IR segment displays one long blink, a leaning
error has occurred. Try repeating this step again until a
successful capture occurs.
6
Press and hold the
least 3 seconds.
• The IR segment blinks twice and the setting is
completed.
• To cancel the learning setup mode, press and hold the RC
SETUP button for at least 3 seconds.
NOTE:
• Do not try to learn anything to the RC SETUP button.

Using the system call function

• A series of operations can be registered at a single button.
• This function makes it possible to for example turn the
amplifier's power on, select the input source, turn the
monitor power's on, turn the source device's power on and
start playback, all by pressing a single button once.
• Up to 32 signals each can be stored at the SYSTEM CALL
button (1, 2 or 3).
84
Other remote
control unit
The AVR-5805CI's remote control
unit (RC-1036)
RC SETUP
button for at