Multi Zone Music Entertainment System; Zone2 Playback - Denon AVR-5805CI Operating Instructions Manual

Multi zone music entertainment system

• When the outputs of the "ZONE2 (ZONE3, ZONE4)" OUT terminals are wired and connected to power amplifiers installed in
other rooms, different sources can be played in rooms other than the MAIN ZONE in which this unit and the playback devices
are installed. (Refer to ZONE2 (ZONE3, ZONE4) on the diagram below.)
• Settings can be made at "Power Amp Assign" in the "System Setup Menu" so that the same source as the ZONE2 (ZONE3,
ZONE4) pre-out terminals can be played from the speakers connected to the ZONE2 (ZONE3, ZONE4) speaker terminals
( page 129 ~ 133).
To control playback devices other than the ones above, either use that device's remote control unit or preset a separately sold
programmable remote control unit.
• For the AUDIO output, use high quality pin-plug cords and wire in such a way that there is no humming or noise.
• For instructions on installation and operation of separately sold devices, refer to the devices' operating instructions.
• Video signals are output from the ZONE3 video output terminals even when the power of ZONE3 is turned off.

ZONE2 playback

• The AVR-5805CI is equipped with pre-out terminals for which the volume is adjustable and video output terminals (composite,
S-Video and component) as the ZONE2 output terminals.
• A separately sold power amplifier or premain amplifier can be connected to enjoy ZONE2 playback.
• The AVR-5805CI ZONE2 monitor output is equipped with a video conversion function, so connect the ZONE2 monitor output
terminal with a video, S-Video or component video cable. For details, see "The video conversion function" (
87
Advanced Operation
page 28).