IBM 6400 - Model 008 B/W Line-matrix Printer Operator's Manual page 96

status and fault messages
Fault Correction Procedure
Press any key on the operator panel,
except Stop, to silence the alarm if
necessary. Pressing the Form Feed key
will silence the alarm and cause the
paper to move. The top-of-form setting
will be lost.
2
Write down the number of the displayed
error message.
3
Use the fault explanation to fix the
problem, if possible.
4
Press Stop to clear the fault message.
Press Start to return to READY state,
and resume printing.
5
If the fault message reappears, power
off the printer, wait 15 seconds, then
power on the printer.
6
Run your print job again. If the fault
message reappears, turn off power to
the printer, then call an IBM service
representative. Otherwise, no further
attention is required.
The following pages list each printer status
message and fault message. For fault messages,
suggestions are offered for correcting the fault
condition.
82 Operator' s Guide