IBM 6400 - Model 008 B/W Line-matrix Printer Operator's Manual page 50

reloading paper
2
Lower the forms thickness lever. Set
it to match the paper thickness.
Refer to the note on the shuttle
cover.
Do not set the forms thickness lever too
tightly; excessive friction can cause paper
jams and ribbon jams with potential for
ribbon damage, smeared ink, or wavy print.
3
Press Cancel to clear the
"END OF FORMS" fault
message from the message
display.
4
Close the printer cover and the
cabinet front door, as required.
5
Press Start to place the printer
in READY state and resume
printing.
6
On cabinet models:
Open the rear cabinet door and
ensure that the paper folds in
the stacker the same way it
does in the supply area.
7
Close the rear cabinet door.
Perform steps 18 through 36 only if you are
unable to load the new paper over the
existing paper in step 3.
8
Open both tractor doors.
36
A
Thin Paper
B
Medium Paper
note
C
Thick Paper
NOTE:
Thin Paper = single sheet
Medium Paper = two–part form
Thick Paper = six–part form
Operator' s Guide