IBM 6400 - Model 008 B/W Line-matrix Printer Operator's Manual page 28

using the operator panel
Start
1) Moves the printer from NOT READY
state to READY state, enabled for
printing.
2) In PROGRAM state, exits the menus
and places the printer in READY
state.
3) After pressing View or Eject to move
the print position to the tractor area,
moves the paper back to its original
print position, and places the printer
in READY state.
Stop
1) Moves the printer from READY state
to NOT READY state, enabled for
operator functions such as viewing
or changing configuration
parameters.
2) In PROGRAM state, exits the menus
and places the printer in the NOT
READY state.
3) In FAULT state, clears the fault if the
problem has been corrected.
4) In the NOT READY state, pressing
Stop + Enter, which is a soft reset,
resets the printer to the power on
configuration.
5) After pressing View or Eject to move
the print position to the tractor area,
press Stop to move the paper back
to its original print position, and
place the printer in the NOT READY
state.
14
Start
Stop
Operator' s Guide