Nokia IP350 - Security Appliance Installation Manual page 68

6
Installing and Replacing Other Components
7. Place the screws through the standoff holes on the card and into the
standoffs on the motherboard.
8. Turn each screw clockwise so that the card is attached to the standoffs.
Do not tighten completely.
9. Make sure that all four standoff connections are properly aligned.
10. To secure the connections, tighten the screws firmly, but do not
overtighten.
11. Slide the chassis assembly back into the appliance and resecure the two
thumbscrews.
Reseating the chassis assembly automatically restores power to the
appliance.
12. Configure your software to use hardware acceleration. For more
information, see
68
Screw
Accelerator card
Standoff hole
Motherboard standoff
Chassis assembly thumbscrews
"" on page 69.
Nokia 60s and 100s Installation Guide
60s
00487