Nokia IP350 - Security Appliance Installation Manual page 88

8
Troubleshooting
Finally, return the entire database to its default settings and bring up the new
system-startup procedure. The new system-startup procedure is described in
Chapter 3, "Performing the Initial
To reset the default database settings
1. Log in to the 60s and 100s appliance as admin by using Voyager.
For information about how to access Voyager and the related reference
materials, see
2. Under Configuration Database Management (Config > System
Configuration > Manage Configuration Sets), choose the option to create
a new factory default configuration.
3. Create the new default configuration.
Do Not Get a Login Prompt—Error Messages Appear
Problem The 60s and 100s appliance is defective, or the file system on the
60s and 100s appliance is defective.
Solution Contact the Nokia customer support site listed in
Information"
Note
Use the full installation procedure to install a new system. The new
system completely replaces the contents of the drive and might be
needed to restore or reload an 60s and 100s appliance. This procedure
erases any configuration database on the appliance. For information
about how to complete the full installation procedure, see the current
release notes. The release notes are located on the Nokia customer
support Web site as listed in the
88
Configuration".
"Accessing Nokia Network Voyager"
on page 3.
"Nokia Contact Information"
on page
"Nokia Contact
on page 3.
Nokia 60s and 100s Installation Guide
34.