Nokia IP350 - Security Appliance Installation Manual page 33

2. Connect the other end of the cable to the VT100 console or to a system
To perform the initial configuration
1. Turn on the appliance.
2. Respond to the
Nokia 60s and 100s Installation Guide
Using a Console Connection to Perform the Initial Configuration
running a terminal-emulation program.
At the console a series of startup messages appears, then the following
prompt appears:
BOOTMGR[0]>
The prompt remains on the screen for about five seconds.
Note
For information about using the boot manager, see
the Boot Manager."
After some miscellaneous output appears, the following prompt appears:
Hostname?
If the prompt does not appear on the console, check the
Hostname?
console port and console display connections to ensure that the serial
cable is completely plugged in at both ends. If you verify the console
connections and still do not see either the
prompts, verify that the terminal or terminal emulator program settings
are correct. If the settings are correct, contact your Nokia service provider
as listed in "Nokia Contact Information"
Hostname?
DHCP client from starting.
If the DHCP client starts, it might configure the appliance with an
incorrect host name and IP address (this could happen if a DHCP server
on your network is configured to respond to any request). To reset the
incorrect host name and IP address:
a. Establish a console connection to the system.
b. Enter the following:
BOOTMGR>
on page 3.
prompt within 30 seconds to prevent the
Chapter 7, "Using
or
Hostname?
33