Upgrading The Boot Manager - Nokia IP350 - Security Appliance Installation Manual

Upgrading the Boot Manager

The command to upgrade your boot manager has the following syntax:
where boot-device is the storage device from which the boot manager loads at
boot up and boot-file is the new boot manager image. The new boot manager
options are
upgrade_bootmgr
boot manager.
For complete upgrade procedures, refer to the appropriate version of release
notes.
Note
To install the new boot manager, you must be in single user mode.
To upgrade the boot manager
1. Get the upgraded boot manager image from the appropriate Nokia
2. Start the 60s or 100s appliance in single-user mode.
3. At the IPSO command prompt, enter:
Nokia 60s and 100s Installation Guide
upgrade_bootmgr boot-device boot-file
,
cpipflash nkipflash
command from IPSO (the operating system), not from the
customer support site as listed in the Nokia Contact Information section at
the front of this guide.
/etc/upgrade_bootmgr wd0 /etc/nkipflash
The command upgrades the boot manager with the new image
( ), writing it into the hard disk dirve (
nkipflash
some time to complete. Do not interrupt the upgrade process.
Upgrading the Boot Manager
, and . Execute the
nkvpnflash
wd0
). The upgrade takes
83