Using A Console Connection To Perform The Initial Configuration - Nokia IP350 - Security Appliance Installation Manual

3
Performing the Initial Configuration
Using a Console Connection to Perform the
Initial Configuration
If you do not use DHCP to perform the initial configuration of your 60s and
100s appliance, you must use a serial console connection (cable included).
After you perform the initial configuration, the console connection is no
longer required.
You can use any standard VT100-compatible terminal with an RS-232 data
terminal equipment (DTE) interface or terminal-emulation program
configured with the following settings for the console:
9600 bps
8 data bits
No parity
1 stop bit
To connect to the console
1. Connect the supplied null-modem cable (console cable) to the console
port on the front panel of the 60s and 100s appliance.
Use only the DB9 port on the front panel labeled Console; the serial
(AUX) port is an auxiliary modem port.
If you connect the console port to a data communications equipment
(DCE) device, use a straight-through cable.
For cable pin assignments for the console connection, see
Console Port"
32
on page 21.
Console port
Nokia 60s and 100s Installation Guide
60s
00487
"Built-in