Using The Boot Manager To Install Ipso - Nokia IP350 - Security Appliance Installation Manual

7
Using the Boot Manager

Using the Boot Manager to Install IPSO

Use the install command to install IPSO. The syntax of the command is:
install
For complete installation procedures, refer to the appropriate version of
release notes.
Note
A full installation using the install command deletes the existing IPSO
image on the 60s or 100s appliance.
To install a new copy of the IPSO kernel
1. At the boot manager command prompt, enter:
BOOTMGR[0]>install
If you used the
password, the boot manager prompts you for your password before
allowing you to execute the
2. Enter the information the
address, the server IP address, and other information).
3. Reboot the 60s or 100s appliance.
80
command to protect this command with a
passwd
install
command requests (your system IP
install
command.
Nokia 60s and 100s Installation Guide