Table of Contents
Advertisement
Message
"Scanner journal is full.
Please check Scanner
Features."
"Selected file is currently in
use. File name cannot be
changed."
"Selected file is currently in
use. Password cannot be
changed."
"Selected file is currently in
use. User name cannot be
changed."
"Sending the data has
failed. The data will be
resent later."
"Some invalid destination(s)
contained. Do you want to
select only valid
destination(s)?"
"Some of selected files are
currently in use. They could
not be deleted."
Causes
"Print & Delete Scanner
Journal" in [Scanner
Features] is set to [Do not
Print: Disable Send], and
Scanner Journal is full.
You cannot change the
name of a file whose status
is "Waiting..." or that is
being edited with
DeskTopBinder.
You cannot change the
password of a file whose
status is "Waiting..." or that is
being edited with
DeskTopBinder.
You cannot change the
sender's name whose status
is "Waiting..." or that is
being edited with
DeskTopBinder.
A network error has
occurred and a file was not
sent correctly.
The specified group contains
e-mail destinations and Scan
to Folder destinations, either
of which are incompatible
with the specified
transmission method.
You cannot delete a file
which is waiting to be
transmitted ("Waiting..."
status displayed) or whose
information is being
changed with
DeskTopBinder.
When Messages Are Displayed on the Control Panel
Solutions
Print or delete Scanner Journal. For
details about Scanner Features, see
"General Settings", Scan
Cancel transmission ("Waiting..." status
cleared) or the DeskTopBinder setting,
and then change the file name.
Cancel transmission ("Waiting..." status
cleared) or the DeskTopBinder setting,
and then change the password.
Cancel transmission ("Waiting..." status
cleared) or the DeskTopBinder setting,
and then change the user name.
Wait until sending is retried
automatically after the preset interval. If
sending fails again, contact your
administrator.
In the message that appears at each
transmission, press [Select].
Cancel transmission ("Waiting..." status
cleared) or the DeskTopBinder setting,
and then delete the file.
.
205
Advertisement
Table of Contents
