Viewing The Power Status Page - Linksys NSS6000 Series Administrator's Manual

Managing the System

Viewing the Power Status Page

Viewing the Power Status Page
NOTE
Linksys Small Business NSS4000 and NSS6000 Series Network Storage System Administration Guide
The Power Status page provides an overview of the current power condition of
the NSS. It is also where you can configure an attached UPS.
When the UPS power goes to low battery, a signal is sent through the USB port on
the NSS and a shutdown of the NSS is initiated. Make sure that the UPS has enough
reserve power to sustain the NSS through the shutdown (approximately 5 minutes).
The Power area displays the following:
•
UPS: These options are available depending on the current operating
condition of the UPS.
-
No Connection: A UPS is not currently connected to the NSS.
-
On Mains: A UPS is connected to the NSS but is not currently being
used to power the unit. The NSS is deriving power from the main power.
-
On Battery (%): The NSS is currently deriving its power from the UPS
battery. The percentage of power still available is also listed and is
color-coded according to the amount of battery remaining.
For more information about the functioning of the UPS, refer to the UPS
documentation.
2
13