Configuring The Nss For Ftp Access - Linksys NSS6000 Series Administrator's Manual

Managing the Shares

Configuring the NSS for FTP Access

Configuring the NSS for FTP Access
NOTE
STEP 1
STEP 2
Linksys Small Business NSS4000 and NSS6000 Series Network Storage System Administration Guide
You can configure the NSS to allow the FTP protocol to be used for file transfers
between the NSS over the Internet. The NSS supports both FTP (faster but not as
secure) and FTPS (not as fast as FTP but more secure). The NSS only supports
Explicit FTPS (versus Implicit FTPS). The NSS does not support SFTP. After you
globally enable FTP access, you can allow or disallow FTP access on a
per-share basis.
FTP is disabled by default. You must enable FTP access before your users can
access the NSS storage through FTP regardless of their per-share settings.
To set up the FTP protocol:
From the Manager Menu, click Shares
The FTP Setup page appears.
To enable FTP, click Enable FTP.
This enables both FTP and FTPS access and activates the remaining FTP
configuration settings on this page.
FTP Setup.
6
114