5)
Set HyperTerminal properties. In the HyperTerminal window, choose File > Properties from the
menu, and select the Settings tab to enter the properties setting dialog box, as shown below.
Select VT100 or Auto detect from the Emulation drop-down list, and click OK to return to the
HyperTerminal window.
Figure 4-6 Set the emulation type
Starting Up the LSQM1WCMB0
Checks Before Power-On
Before starting up the access controller module, verify that:
The power cables and ground cable are correctly connected.
The power outlet voltage meets the voltage requirement of the switch.
The console cable is correctly connected, the console terminal or PC is running, and the terminal
parameters are properly set.
Powering On the Access Controller Module
Upon power-on of the LSQM1WCMB0, the console terminal displays the following information:
*******************************************
*
*
*
*******************************************
Copyright(c) 2004-2007 Hangzhou H3C Tech. Co., Ltd.
H3C WCMB BootWare , Ver 1.08
*
*
*
4-4