Table of Contents
Advertisement
•
Username—admin
•
Password—admin
To access the device from the console port:
1.
Use a console cable to connect the console port on the device to a configuration terminal, for
example, a PC.
2.
Run a terminal emulator program, TeraTermPro or PuTTY, on your configuration terminal.
For more information about the terminal emulator programs, see the user guides for these
programs.
3.
Configure the terminal settings as follows:
Bits per second—9,600.
Data bits—8.
Stop bits—1.
Parity—None.
Flow control—None.
Logging in from the Web interface
IMPORTANT:
After accessing the Web interface with the default account, modify the password of the default
account or create a new administrator account and delete the default account as a best practice.
At the first login from the Web interface, you can use the default account or use an account created
from the CLI.
The default Web interface login information is as follows:
•
Username—admin
•
Password—admin
•
IP address of GigabitEthernet 1/0/0—192.168.0.1/24
To log in to the device from the Web interface by using the default account:
1.
Use an Ethernet cable to connect a PC to Ethernet management port GigabitEthernet 1/0/0 on
the device.
2.
Configure an IP address in subnet 192.168.0.0/24 for the PC. Make sure the PC and the device
are reachable to reach other.
The PC must use a different IP address than GigabitEthernet 1/0/0.
3.
Start a browser, enter 192.168.0.1 in the address bar, and press Enter.
4.
Enter the default username admin and password admin and then click Login.
Logging in through Telnet
1.
Log in to the device through the console port, and enable the Telnet function in system view by
using the
2.
Enter VTY user line view, and configure the authentication mode, user role, and common
properties.
By default, the authentication mode is scheme, the username is admin, and the password is
admin.
3.
Specify an IP address for the PC. Make sure the PC and the device are reachable to each
other.
By default, the IP address of GigabitEthernet 1/0/0 on the device is 192.168.0.1/24.
telnet server enable
command.
22
Advertisement
Table of Contents
