Upgrading Applications Through The Management Ethernet Interface - H3C WIRELESSACCESSCOTROLLER S7500E Installation Manual

Waiting ...CCCCCCCCCC
4) Select and send the application file using HyperTerminal. The procedure for upgrading an
application file is the same as upgrading the BootWare. For details, refer to section "Upgrading the
BootWare through a serial connection" on page 5-9.
The size of an application program is typically over 10 MB. Even at the baud rate of 115,200 bps, the
upgrade takes about 30 minutes. Therefore, you are recommended to upgrade an application program
through an Ethernet interface.

Upgrading Applications Through the Management Ethernet Interface

Select 3 in the BootWare main menu to enter the Ethernet interface submenu. For details about this
submenu, refer to section "Ethernet interface submenu" on page 5-5.
Configuring Ethernet interface parameters
Before upgrading an application program through an Ethernet interface, you need to configure the
Ethernet interface of the LSQM1WCMB0 access controller module, as follows.
Select 3 in the BootWare main menu to enter the Ethernet interface submenu. Then, select 5 to enter
the Ethernet interface configuration submenu:
============================<ETHERNET PARAMETER SET>===========================
|Note: '.' = Clear field.
| '-' = Go to previous field.
| Ctrl+D = Quit.
===============================================================================
Protocol (FTP or TFTP) :tftp
Load File Name
Target File Name
Server IP Address
Local IP Address
Gateway IP Address
When configuring a parameter, you can enter a new value directly, or press Enter to accept the default
value that follows a colon. Type . to clear the current input, - to return to the previous parameter field,
and press Ctrl+D to quit from the parameter configuration interface.
Upgrading applications through the management Ethernet interface
The Trivial File Transfer Protocol (TFTP) is used for upgrading applications through the management
Ethernet interface. TFTP is a TCP/IP protocol used for file transfer between client and server. It provides
:main.bin
:main.bin
:192.168.0.1
:192.168.0.2
:192.168.0.10
5-14
|
|
|