H3C WIRELESSACCESSCOTROLLER S7500E Installation Manual page 20

Compiled date
CPU type
CPU L1 Cache
CPU Clock Speed : 600MHz
Memory Type
Memory Size
Memory Speed
BootWare Size
cfa0 Size
CPLD Version is 003
PCB Version is Ver.C
Press Ctrl+B to enter extend boot menu...
The last line provides you an access to the Boot Menu.
To enter the BootWare main menu, press Ctrl + B within five seconds. For details about the
BootWare main menu, refer to section "BootWare Main Menu" on page 5-3. If you perform no
operation or press a key other than Ctrl + B within five seconds, once the remaining comes to 0,
the system starts the auto boot process. The following information appears:
The current starting file is main application file--flash:/main.bin!
The main application file is self-decompressing........................................
........................................................................................
........................................................................................
........................................................................................
........................................................................................
........................................................................................
..................OK!
System is starting...
User interface con0 is available.
Press ENTER to get started.
The information above indicates that the auto boot of the LSQM1WCMB0 access controller module is
completed.
Press Enter. The following prompt appears:
<H3C>
This means that the LSQM1WCMB0 is ready to configure.
: Nov 17 2006, 12:20:43
: BCM1125H
: 32KB
: DDR SDRAM
: 1024MB
: 166MHz
: 512KB
: 256MB
4-5