Removing The Lsqm1Wcmb0; Installing The Lsqm1Wcmb0 - H3C WIRELESSACCESSCOTROLLER S7500E Installation Manual

Removing the LSQM1WCMB0

Figure 3-2 Remove the LSQM1WCMB0
1) Face the front side of the switch.
2) Loosen the captive screws on the access controller module with a Philips screwdriver.
3) Simultaneously pivot the ejector levers of the access controller module away from the front panel to
detach the board from the backplane.
4) Gently pull the access controller module out of the slot along the guide rails.
5) If the slot is to remain empty, install a blank filler panel to prevent dust from getting into the switch
chassis and ensure good ventilation.

Installing the LSQM1WCMB0

1) Face the front side of the switch.
2) Choose an empty slot and remove the blank filler panel.
3) Push the access controller module into slot along the guide rails until the positioning hole of the
board is seated onto the positioning pin on the backplane.
4) Pivot the ejector levers toward the front panel to lock the access controller module in place.
5) Fasten the captive screws on the access controller module with a Philips screwdriver.
6) If the switch is powered off, power on the switch.
3-3