Configuration Example; Configuring Protection Functions - H3C LS-3100-52P-OVS-H3 Operation Manual

Configuration Procedure
Follow these steps to configure No Agreement Check:
To do...
Enter system view
Enter
interface or
port group
view
Enable No Agreement Check
To make the No Agreement Check feature take effect, enable it on the root port.

Configuration Example

Network requirements
Device A connects to a third-party's device that has different MSTP implementation. Both devices
are in the same region.
Another vendor's device is the regional root bridge, and Device A is the downstream device.
Figure 1-9 No Agreement Check configuration
Configuration procedure
# Enable No Agreement Check on GigabitEthernet 1/0/1 of Device A.
<DeviceA> system-view
[DeviceA] interface gigabitethernet 1/0/1
[DeviceA-GigabitEthernet1/0/1] stp no-agreement-check

Configuring Protection Functions

An MSTP-enabled device supports the following protection functions:
BPDU guard
Root guard
Use the command...
system-view
Enter Ethernet
interface view
interface interface-type
or Layer-2
interface-number
aggregate
interface view
Enter port port-group manual
group view port-group-name
stp no-agreement-check
1-36
Remarks
—
Required
Use either command.
Configurations made in
interface view will take effect
on the current port only;
configurations made in port
group view will take effect on
all ports in the port group.
Required
Not enabled by default