Configuring A Protocol-Based Vlan - H3C LS-3100-52P-OVS-H3 Operation Manual

Configuring a Protocol-Based VLAN

Follow these steps to configure a protocol-based VLAN:
To do...
Enter system view
Enter VLAN view
Create a protocol template for the
VLAN
Exit VLAN view
Enter interface
view or port
group view
Configure the port link type as
hybrid
Configure the port(s) to permit the
packets of the specified
protocol-based VLANs to pass
through untagged
Associate the hybrid port(s) with
the specified protocol-based
VLAN
Use the command...
system-view
vlan vlan-id
protocol-vlan
[ protocol-index ] { at | ipv4 |
ipv6 | ipx { ethernetii | llc |
raw | snap } | mode
{ ethernetii etype etype-id |
llc { dsap dsap-id [ ssap
ssap-id ] | ssap ssap-id } |
snap etype etype-id } }
quit
Enter Ethernet interface interface-type
interface view interface-number
Enter Layer-2
interface
aggregate bridge-aggregation
interface view interface-number
Enter port port-group manual
group view port-group-name
port link-type hybrid
port hybrid vlan vlan-id-list
untagged
port hybrid protocol-vlan
vlan vlan-id { protocol-index
[ to protocol-end ] | all }
1-12
Remarks
—
Required
If the specified VLAN does
not exist, this command
creates the VLAN first.
Required
Required
Required
Use either command.
In Ethernet interface view,
the subsequent
configurations apply to the
current port.
In port group view, the
subsequent configurations
apply to all ports in the port
group.
In Layer-2 aggregate
interface view,
subsequent configurations
apply to the Layer-2
aggregate interface and all
its member ports.
Required
Required
Required
the