Table of Contents
Advertisement
Follow these steps to configure basic Ethernet OAM functions:
To do...
Enter system view
Enter Ethernet port view
Set Ethernet OAM operating
mode
Enable Ethernet OAM on the
current port
Configuring Link Monitoring
After Ethernet OAM connections are established, the link monitoring periods and thresholds configured
in this section take effect on all Ethernet ports automatically.
Configuring Errored Symbol Event Detection
An errored symbol event occurs when the number of detected symbol errors over a specific detection
interval exceeds the predefined threshold.
Follow these steps to configure errored symbol event detection:
To do...
Enter system view
Configure the errored symbol
event detection interval
Configure the errored symbol
event triggering threshold
Configuring Errored Frame Event Detection
An errored frame event occurs when the number of detected error frames over a specific interval
exceeds the predefined threshold.
Use the command...
System-view
interface interface-type
interface-number
oam mode { active | passive }
oam enable
Use the command...
system-view
oam errored-symbol period
period-value
oam errored-symbol threshold
threshold-value
1-6
Remarks
—
—
Optional
The default is active Ethernet
OAM mode.
Required
Ethernet OAM is disabled by
default.
Remarks
—
Optional
1 second by default
Optional
1 by default
Advertisement
Chapters
Table of Contents
Troubleshooting
