Rrpp Typical Configuration Examples; Configuring Single Ring Topology - H3C LS-3100-52P-OVS-H3 Operation Manual

To do...
Clear RRPP statistics

RRPP Typical Configuration Examples

Configuring Single Ring Topology

Networking requirements
Device A, Device B, Device C, and Device D constitute RRPP domain 1, specify the primary control
VLAN of RRPP domain 1 as VLAN 4092, and RPPP domain 1 protects all VLANs;
Device A, Device B, Device C and Device D constitute primary ring 1;
Specify Device A as the master node of primary ring 1, GigabitEthernet 1/0/1 as the primary port
and GigabitEthernet 1/0/2 as the secondary port;
Specify Device B, Device C and Device D as the transit nodes of primary ring 1, their
GigabitEthernet 1/0/1 as the primary port and GigabitEthernet 1/0/2 as the secondary port;
The timers of the primary ring adopt the default value.
First, determine the node mode of a device in an RRPP ring, and then perform the following
configurations on a per-device basis:
Disable STP on all ports accessing RRPP rings on these devices and configure these ports to
permit the traffic of all VLANs to pass through.
Configure the 802.1p priority for trusted packets on ports accessing RRPP rings on each device.
Create an RRPP domain.
Specify the control VLAN for the RRPP domain.
Configure the MSTIs referenced by the protected VLANs. The MSTI ID ranges from 0 to 32.
Specify the node mode of a device on the primary ring and the ports accessing the RRPP ring on
the device.
Enable the RRPP ring.
Enable RRPP.
Figure 1-8 Network diagram for single ring networking configuration
Use the command...
reset rrpp statistics domain
domain-id [ ring ring-id ]
1-18
Remarks
Available in user view