Setting The Link Type Of A Port To P2P - H3C LS-3100-52P-OVS-H3 Operation Manual

Configuration procedure
Follow these steps to specify a port or a group of ports as edge port(s):
To do...
Enter system view
Enter
interface view
or port group
view
Configure the port(s) as edge
port(s)
With BPDU guard disabled, when a port set as an edge port receives a BPDU from another port, it
will become a non-edge port again. To restore the edge port, re-enable it.
If a port directly connects to a user terminal, configure it as an edge port and enable BPDU guard
for it. This enables the port to transition to the forwarding state fast while ensuring network security.
Configuration example
# Configure GigabitEthernet 1/0/1 to be an edge port.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] stp edged-port enable

Setting the Link Type of a Port to P2P

A point-to-point link is a link directly connecting two devices. If the two ports across a point-to-point link
are root ports or designated ports, the ports can rapidly transition to the forwarding state after a
proposal-agreement handshake process.
Use the command...
system-view
Enter Ethernet
interface view
interface interface-type
or Layer-2
interface-number
aggregate
interface view
Enter port port-group manual
group view
port-group-name
stp edged-port enable
—
Required
Use either command.
Configurations made in interface
view will take effect on the current
port only; configurations made in
port group view will take effect on all
ports in the port group.
Required
All Ethernet ports are non-edge
ports by default.
1-24
Remarks