Protocols And Standards; Lldp Configuration Task List; Performing Basic Lldp Configuration; Enabling Lldp - H3C LS-3100-52P-OVS-H3 Operation Manual

Extended power-via-MDI TLV, which carries the information about the power supply capability of
the current device.
Hardware revision TLV, which carries the hardware version of an MED device.
Firmware revision TLV, which carries the firmware version of an MED device.
Software revision TLV, which carries the software version of an MED device.
Serial number TLV, which carries the serial number of an MED device.
Manufacturer name TLV, which carries the manufacturer name of an MED device.
Model name TLV, which carries the model of an MED device.
Asset ID TLV, which carries the asset ID of an MED device. Asset ID is used for directory
management and asset tracking.
Location identification TLV, which carries the location identification of a device. Location
identification can be used in location-based applications.
For detailed information about LLDP TLV, refer to IEEE 802.1AB-2005 and ANSI/TIA-1057.

Protocols and Standards

IEEE 802.1AB-2005, Station and Media Access Control Connectivity Discovery
ANSI/TIA-1057, Link Layer Discovery Protocol for Media Endpoint Devices

LLDP Configuration Task List

Complete these tasks to configure LLDP:
Basic LLDP
configuration
Configuring the Encapsulation Format for LLDPDUs
Configuring the Encapsulation Format of the Management Address
Configuring CDP Compatibility
Configuring LLDP Trapping

Performing Basic LLDP Configuration

Enabling LLDP

Follow these steps to enable LLDP:
Task
Enabling LLDP
Setting LLDP Operating Mode
Configuring LLDPDU TLVs
Enable LLDP Polling
Configuring the Parameters Concerning LLDPDU Sending
1-4
Remarks
Required
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional